The Fiat 500X has been built since 2014.
For this generation we cover 4 engines and 22 known faults, each with the mileage range where it usually appears.
The most expensive known risk is TCT / DCT actuator & clutch: it usually appears at 60,000–160,000 km and costs €800–2,200 to fix.
In UK roadworthiness tests in 2024, at 50–100 thousand km this model most often failed on: lights, wipers and visibility (9.8 %), tyres and wheels (6.6 %), steering (5.8 %). It fails more often than an average car of the same age and mileage on: steering, lights, wipers and visibility, exhaust, emissions and leaks. It fails less often than average on: brakes.
Faults typical of this model ✓ Checked against sources (10/2026)
Front position lamps and rear lights fail (inspection defect)
usually 30,000–200,000 km · Wear part
Signs: Front side/position lamp or a rear lamp dead, often found only at the technical inspection.
Fix: Check all lamps before inspection; replace the bulb or LED unit and check the holder and connector for corrosion.
€20–300
Rear brake discs worn, pitted or rusted early
usually 60,000–200,000 km · Wear part
Signs: Rusty, pitted or scored rear discs found at inspection; noise or poor rear braking result.
Fix: Inspect rear discs at every service, brake firmly now and then to keep them clean, replace discs with pads when pitted.
€150–300
Instrument cluster blanks out or shows false warnings
usually 10,000–150,000 km · Wear part
Signs: Cluster goes dark for a while, or engine, tyre pressure, airbag and parking brake warnings come on without a fault.
Fix: Check the battery and charging voltage first, read all modules and update software; replace the cluster only if the fault stays.
€50–600
Recall: rear seat backrest latch may release in a crash
usually 0–200,000 km · High risk
model years 2015–2018 only
Signs: Usually no warning; the backrest may fold forward in a crash and let luggage into the cabin.
Fix: Check by VIN with a Fiat dealer that the new latch was fitted; free of charge.
free / recall
Recall: airbag and belt-tensioner control unit software
usually 0–200,000 km · High risk
model years 2017–2019 only
Signs: Usually no warning; airbags and belt tensioners may not work fully in a crash.
Fix: Check by VIN with a Fiat dealer that the control unit software was updated; free of charge.
free / recall
Faults by engine
1.6 / 2.0 MultiJet II (JTDm / DDiS) ✓ Checked against sources (10/2026)
Faults and service: Fiat 500X with this engine →
Coolant loss from EGR cooler or water pump leak
usually 80,000–180,000 km · Medium risk
Signs: Coolant level keeps dropping, damp traces near the pump or EGR cooler, white smoke or EGR faults, temperature warning
Fix: Pressure-test the cooling system; replace the EGR cooler or the water pump (pump best together with the timing belt)
€200–900
EGR valve sooting or cracked EGR housing
usually 80,000–180,000 km · Medium risk
Signs: EGR fault codes, power loss, higher fuel use, more frequent regenerations
Fix: Check EGR operation in live data; clean or replace the valve
€200–600
DPF clogging or faulty DPF pressure sensor
usually 80,000–200,000 km · Medium risk
Signs: DPF light, frequent or incomplete regenerations, power loss, higher fuel use; mainly with short trips
Fix: Check the differential pressure sensor and hoses first; forced regeneration, cleaning or a new filter
€100–1,500
Oil diluted by regeneration; early 'change oil' warning
usually 20,000–200,000 km · Wear part
Signs: Flashing oil warning or 'change oil' message well before the service, oil level above max; rev limit if ignored
Fix: Change the oil and reset the counter; avoid only short trips so regenerations can finish
€80–150
Turbo failure or sticking variable vanes
usually 120,000–220,000 km · Medium risk
Signs: Loss of boost, hesitant throttle, whistling, smoke, limp mode
Fix: Check boost hoses and the actuator first; replace the turbo if worn (rebuilds are often not worth it)
€300–1,300
1.3 MultiJet / CDTI / DDiS / TDCi ✓ Checked against sources (10/2026)
Faults and service: Fiat 500X with this engine →
Timing chain stretch and tensioner wear
usually 100,000–200,000 km · High risk
Signs: Metallic rattle from the chain side on cold start, crank/cam correlation fault code, engine light
Fix: Measure the crank/cam deviation with a diagnostic tool; replace the chain kit with tensioner and guides before the chain jumps
€800–1,300
Injector faults or leaking injector seals
usually 80,000–200,000 km · Medium risk
Signs: Hard starting, rough or knocking idle when cold, power loss, higher fuel use, sometimes limp mode
Fix: Read per-cylinder correction values and back-leak; repair or replace only the faulty injector and renew its seal
€200–1,200
EGR valve sooting
usually 80,000–180,000 km · Medium risk
Signs: Engine light, rough idle, hesitation, power loss or limp mode; worse with short trips
Fix: Check EGR movement in live data; clean or replace the valve
€200–500
DPF clogging or faulty DPF pressure sensor / hoses
usually 80,000–200,000 km · Medium risk
Signs: DPF light, interrupted or frequent regenerations, limp mode; mainly with short trips
Fix: Check and clean the pressure sensor hoses first, then read soot load; forced regeneration, cleaning or a new filter
€100–1,500
Turbo variable vanes or actuator sticking
usually 100,000–200,000 km · Medium risk
Signs: Boost fault codes, power loss, limp mode, sometimes whistling or smoke
Fix: Check boost control and charge-air hoses for leaks first; free or replace the actuator, replace the turbo only if it is worn
€150–1,300
Glow plugs or glow plug control unit failure
usually 80,000–200,000 km · Wear part
Signs: Hard starting in cold weather, smoke after a cold start, glow plug warning light
Fix: Test the plugs and the control unit; replace faulty parts (seized plugs may need extraction)
€100–400
1.0 / 1.3 FireFly (incl. turbo / mild hybrid) ✓ Checked against sources (10/2026)
Faults and service: Fiat 500X with this engine →
No typical faults on record.
1.4 T-Jet / MultiAir (turbo) Not checked yet
MultiAir actuator ('brick') failure
usually 80,000–160,000 km · High risk
Signs: Misfire, rough idle, engine light, runs on 3 cylinders
Fix: Replace MultiAir unit; use correct 5W-40 oil
€600–1,300
Turbo wastegate / boost leaks
usually 80,000–160,000 km · Wear part
Signs: Loss of power
Fix: Replace actuator or hoses
€150–500
Gearboxes
Manual
Clutch wear
usually 120,000–200,000 km · Medium risk
Signs: Slipping, high bite point
Fix: Replace clutch kit
€500–900
Dual-mass flywheel
usually 150,000–220,000 km · Medium risk
Signs: Rattle at idle, vibration pulling away
Fix: Replace with clutch
€700–1,400
DCT / TCT (C635, dry clutch)
TCT / DCT actuator & clutch
usually 60,000–160,000 km · Medium risk
Signs: Jerky shifts, gearbox warning
Fix: Actuator / clutch replacement
€800–2,200
Automatic (Aisin 6-speed / ZF 9HP)
ZF 9HP rough shifts / software
usually 20,000–120,000 km · Wear part
Signs: Harsh or delayed shifts
Fix: Software update; fluid service
€0–400
Scheduled service
Intervals and typical prices for the 1.6 / 2.0 MultiJet II (JTDm / DDiS) engine. Other engines differ in oil, timing drive and some filters; the app gives the exact plan.
Roadworthiness tests by mileage
Share of tests in the United Kingdom (DVSA MOT, 2024) that this model failed because of each system. Bold red means more often and green less often than an average car of the same age and mileage. Sample: 34,367 tests.
Roadworthiness tests in the Netherlands by age
Share of this model's Dutch fleet that had a defect in each system at a roadworthiness test (APK) in 2025. Bold red means more often and green less often than an average car of the same age and fuel. Sample: 6,396 cars.
Most common engine versions in the EU
New cars of this generation registered in the EU, Iceland and Norway 2010–2025: 620,559, of which 433 in Croatia. The share shows how common each version is.
Source: European Environment Agency (EEA), monitoring of CO₂ emissions from new passenger cars, CC BY 4.0. CO₂ and fuel use are official type-approval values (WLTP from 2021), not real-world consumption.
Owner complaints in the US
Which systems owners reported to the US agency NHTSA and at what mileage. Complaints are not confirmed faults and some relate to recalls. Sample: 139 complaints.
Engineusually 28–76 thousand km (median 51)
28 %Gearbox and drivetrainusually 32–98 thousand km (median 61)
24 %Electrics and electronicsusually 31–88 thousand km (median 54)
20 %
Official recalls
Recalls the manufacturer published in the United Kingdom for this model (5). The same recalls usually apply across Europe. Ask an authorised dealer to check by VIN whether your car is affected and whether the work has been done.
- Fire risk Affected vehicles may have been fitted with a faulty 48-volt battery. This may lead to a loss of the functionality of the battery. This may result in a risk of thermal run away in the case of water infiltration.06/07/2023 · R/2023/168
- Brakes / ABS / ESP The rear right brake calliper could display micro cracks20/11/2020 · R/2020/273
- Airbag Non-conformity in the air bag control module software14/06/2019 · R/2019/161
- Airbag If rear seat belts are not fastened and pretensioners are deployed the latch could be released07/09/2018 · R/2018/216
- Engine / loss of power Loss of drive03/03/2017 · R/2017/046
Common questions
Does the Fiat 500X have a timing chain or a timing belt?
1.6 / 2.0 MultiJet II (JTDm / DDiS): belt · 140,000 km / every 60 mo; 1.3 MultiJet / CDTI / DDiS / TDCi: chain; 1.0 / 1.3 FireFly (incl. turbo / mild hybrid): chain; 1.4 T-Jet / MultiAir (turbo): belt · 120,000 km.
What are the known problems with the Fiat 500X?
The faults with the highest risk: timing chain stretch and tensioner wear (100,000–200,000 km, €800–1,300); multiAir actuator ('brick') failure (80,000–160,000 km, €600–1,300); TCT / DCT actuator & clutch (60,000–160,000 km, €800–2,200); DPF clogging or faulty DPF pressure sensor (80,000–200,000 km, €100–1,500). The full list by engine is on this page.
What does the Fiat 500X most often fail its roadworthiness test on?
In UK roadworthiness tests in 2024, at 50–100 thousand km this model most often failed on: lights, wipers and visibility (9.8 %), tyres and wheels (6.6 %), steering (5.8 %). It fails more often than an average car of the same age and mileage on: steering, lights, wipers and visibility, exhaust, emissions and leaks. It fails less often than average on: brakes.
What should you check when buying a used Fiat 500X?
Before you buy, ask an authorised dealer to check by VIN that the recalls have been done (5 have been published for this model). If the engine has a timing belt, ask for the invoice for its replacement: with no proof, assume it has not been done. On the test drive, watch for these signs: metallic rattle from the chain side on cold start, crank/cam correlation fault code, engine light; misfire, rough idle, engine light, runs on 3 cylinders. The full checklist is in the guide to buying a used car.
Sources and notes
Main sources for the faults of this model (suspension, brakes, electrics, body, recalls) and gearboxes:
Faults, intervals and prices are indicative and collected from public sources and owner experience; always rely on the service book and a qualified workshop. Test statistics: DVSA – Anonymised MOT tests and results, Open Government Licence v3.0. Dutch tests: RDW Open Data (CC0). Engine versions: EEA, monitoring of CO₂ emissions from new passenger cars (CC BY 4.0, DG CLIMA). Owner complaints: NHTSA ODI (public domain). Recalls: DVSA Vehicle Safety Branch Recalls Database, OGL v3.0. Brand and model names are trademarks of their owners and are used only to describe the vehicles. How we check the data →
Updated 21/11/2026