The 1.6 / 2.0 MultiJet II (JTDm / DDiS) engine was fitted to the Fiat 500X (2014–now). In the EU that is 32.1 % of all new cars of this generation.
Versions: 1.6 120 hp, 2.0 140 hp, 1.6, 1.6 131 hp.
The most expensive known risk is DPF clogging or faulty DPF pressure sensor: it usually appears at 80,000–200,000 km and costs €100–1,500 to fix.
Engine faults ✓ Checked against sources (10/2026)
✓ The faults of this engine were checked against sources (10/2026). Each item has at least two independent sources or an official recall or parts-maker technical note.
Coolant loss from EGR cooler or water pump leak
usually 80,000–180,000 km · Medium risk
Signs: Coolant level keeps dropping, damp traces near the pump or EGR cooler, white smoke or EGR faults, temperature warning
Fix: Pressure-test the cooling system; replace the EGR cooler or the water pump (pump best together with the timing belt)
€200–900
EGR valve sooting or cracked EGR housing
usually 80,000–180,000 km · Medium risk
Signs: EGR fault codes, power loss, higher fuel use, more frequent regenerations
Fix: Check EGR operation in live data; clean or replace the valve
€200–600
DPF clogging or faulty DPF pressure sensor
usually 80,000–200,000 km · Medium risk
Signs: DPF light, frequent or incomplete regenerations, power loss, higher fuel use; mainly with short trips
Fix: Check the differential pressure sensor and hoses first; forced regeneration, cleaning or a new filter
€100–1,500
Oil diluted by regeneration; early 'change oil' warning
usually 20,000–200,000 km · Wear part
Signs: Flashing oil warning or 'change oil' message well before the service, oil level above max; rev limit if ignored
Fix: Change the oil and reset the counter; avoid only short trips so regenerations can finish
€80–150
Turbo failure or sticking variable vanes
usually 120,000–220,000 km · Medium risk
Signs: Loss of boost, hesitant throttle, whistling, smoke, limp mode
Fix: Check boost hoses and the actuator first; replace the turbo if worn (rebuilds are often not worth it)
€300–1,300
Gearboxes
Manual
Clutch wear
usually 120,000–200,000 km · Medium risk
Signs: Slipping, high bite point
Fix: Replace clutch kit
€500–900
Dual-mass flywheel
usually 150,000–220,000 km · Medium risk
Signs: Rattle at idle, vibration pulling away
Fix: Replace with clutch
€700–1,400
DCT / TCT (C635, dry clutch)
TCT / DCT actuator & clutch
usually 60,000–160,000 km · Medium risk
Signs: Jerky shifts, gearbox warning
Fix: Actuator / clutch replacement
€800–2,200
Automatic (Aisin 6-speed / ZF 9HP)
ZF 9HP rough shifts / software
usually 20,000–120,000 km · Wear part
Signs: Harsh or delayed shifts
Fix: Software update; fluid service
€0–400
Service plan for this engine
Typical routine maintenance cost for 100,000 km: €2,850–6,650. Sum of the services and wear parts in the plan above (about 15,000 km a year, independent workshop), without faults.
Intervals and typical prices for the Fiat 500X with the 1.6 / 2.0 MultiJet II (JTDm / DDiS) engine. The app gives the exact plan for your mileage.
Versions of this engine in the Fiat 500X
Source: European Environment Agency (EEA), monitoring of CO₂ emissions from new passenger cars, CC BY 4.0. CO₂ and fuel use are official type-approval values (WLTP from 2021), not real-world consumption.
Official recalls
Recalls the manufacturer published in the United Kingdom for this model (5). The same recalls usually apply across Europe. Ask an authorised dealer to check by VIN whether your car is affected and whether the work has been done.
- Fire risk Affected vehicles may have been fitted with a faulty 48-volt battery. This may lead to a loss of the functionality of the battery. This may result in a risk of thermal run away in the case of water infiltration.06/07/2023 · R/2023/168
- Brakes / ABS / ESP The rear right brake calliper could display micro cracks20/11/2020 · R/2020/273
- Airbag Non-conformity in the air bag control module software14/06/2019 · R/2019/161
- Airbag If rear seat belts are not fastened and pretensioners are deployed the latch could be released07/09/2018 · R/2018/216
- Engine / loss of power Loss of drive03/03/2017 · R/2017/046
Common questions
What are the biggest risks of the Fiat 500X with the 1.6 / 2.0 MultiJet II (JTDm / DDiS) engine?
The faults with the highest risk: DPF clogging or faulty DPF pressure sensor (80,000–200,000 km, €100–1,500); turbo failure or sticking variable vanes (120,000–220,000 km, €300–1,300); coolant loss from EGR cooler or water pump leak (80,000–180,000 km, €200–900); EGR valve sooting or cracked EGR housing (80,000–180,000 km, €200–600).
Does the Fiat 500X 1.6 / 2.0 MultiJet II (JTDm / DDiS) have a timing belt or a chain?
Belt · 140,000 km / every 60 mo.
Which oil does the Fiat 500X 1.6 / 2.0 MultiJet II (JTDm / DDiS) need?
5W-30 · Fiat 9.55535-S1 · ~4.2–4.9 L · every 15,000 km.
Sources and notes
Main sources for the faults of this engine:
Faults, intervals and prices are indicative and collected from public sources and owner experience; always rely on the service book and a qualified workshop. Test statistics: DVSA – Anonymised MOT tests and results, Open Government Licence v3.0. Dutch tests: RDW Open Data (CC0). Engine versions: EEA, monitoring of CO₂ emissions from new passenger cars (CC BY 4.0, DG CLIMA). Owner complaints: NHTSA ODI (public domain). Recalls: DVSA Vehicle Safety Branch Recalls Database, OGL v3.0. Brand and model names are trademarks of their owners and are used only to describe the vehicles. How we check the data →
Updated 29/10/2026