The Nissan Pulsar was built from 2014 to 2018.
For this generation we cover 2 engines and 11 known faults, each with the mileage range where it usually appears.
The most expensive known risk is belt slip and pulley wear, debris in the valve body (limp mode): it usually appears at 80,000–200,000 km and costs €800–4,500 to fix.
In UK roadworthiness tests in 2024, at 50–100 thousand km this model most often failed on: suspension (7.9 %), brakes (6.0 %), tyres and wheels (6.0 %). It fails more often than an average car of the same age and mileage on: brakes, suspension, steering. It fails less often than average on: lights, wipers and visibility, body and corrosion.
Faults by engine
1.2 TCe / DIG-T (H5Ft) ✓ Checked against sources (10/2026)
Faults and service: Nissan Pulsar with this engine →
High oil consumption, burnt exhaust valves, engine failure (2012-2018)
usually 50,000–130,000 km · High risk
model years 2012–2018 only
Signs: Oil level drops fast (can exceed 1 L per 1,000 km), low oil warning, blue smoke, loss of power, misfire or engine noise; often unnoticed until damage is done
Fix: Check the dipstick every fill-up; ask a Renault/Dacia/Nissan dealer by VIN for the ECU recalibration and an oil consumption test and file a goodwill request with the service history; if consumption stays high, the engine needs rings/pistons and valve work or a replacement engine
€0–6,000
Timing chain stretch or jumped timing after low oil level
usually 60,000–160,000 km · High risk
model years 2012–2018 only
Signs: Rattle on cold start, camshaft/crankshaft correlation fault codes, rough running; if the chain jumps or breaks the valves are damaged
Fix: Keep the oil level correct; at the first rattle or correlation code replace the chain, tensioner, guides and sprockets
€700–1,500
1.5 dCi (K9K) ✓ Checked against sources (10/2026)
Faults and service: Nissan Pulsar with this engine →
Injector wear (high return flow, rough running)
usually 150,000–250,000 km · Medium risk
Signs: Hard hot starting, rough idle, black smoke, power loss, return flow out of tolerance on the test
Fix: Return-flow (leak-off) test and live-data correction check; recondition or replace the faulty injectors with new copper seals
€400–1,400
EGR valve coking
usually 80,000–200,000 km · Medium risk
Signs: Jerky idle, black smoke, power loss, EGR fault codes (e.g. P0401); worse with short town trips
Fix: Check EGR position in live data; clean the valve and intake, replace the valve if it sticks or its motor fails
€200–700
DPF clogging, failed regenerations
usually 80,000–200,000 km · Medium risk
Signs: DPF warning, frequent or interrupted regenerations, limp mode; mostly cars used for short trips
Fix: Check the differential pressure sensor and EGR first, then forced regeneration, cleaning or replacement; use low-ash RN0720 oil
€150–1,500
Turbocharger failure (oil supply, boost hose)
usually 120,000–250,000 km · Medium risk
Signs: Whistling, blue smoke, oil use, loss of power or limp mode (P0299 underboost)
Fix: First check boost hoses and clamps and the intercooler pipes; if the turbo has play, replace it and clean or replace the oil feed line and check oil pressure
€100–1,400
High oil consumption (Blue dCi built 2018-2021, ECU update)
usually 0–100,000 km · Medium risk
model years 2018–2021 only
Signs: Oil level drops quickly between services, oil can reach the intake; risk of running low on oil
Fix: Check the oil level often; ask a Renault/Dacia dealer for the free ECU reprogramming campaign and an oil-consumption test
€0–200
Gearboxes
Manual
Clutch wear
usually 120,000–200,000 km · Medium risk
Signs: Slipping, high bite point
Fix: Replace clutch kit
€500–900
X-Tronic / Xtronic CVT (Jatco)
Belt slip and pulley wear, debris in the valve body (limp mode)
usually 80,000–200,000 km · High risk
Signs: Judder pulling away, engine revs flare without the car speeding up, delay when selecting D or R, power cut / limp mode when hot
Fix: Read the CVT codes and check the fluid for metal; if caught early replace the valve body and fluid and flush the cooler, otherwise fit a reconditioned CVT
€800–4,500
Low-speed CVT judder code (P17F0 / P17F1) on JF016E / JF017E
usually 30,000–150,000 km · High risk
model years 2013–2018 only
Signs: Shaking, shudder or repeated bumps when pulling away or at low speed, judder fault stored in the gearbox control unit
Fix: Dealer-level diagnosis: P17F1 usually means a new valve body (if the belt is not slipping), P17F0 means a gearbox replacement; reprogram the control unit and flush the cooler
€800–4,500
CVT pulley bearing whine
usually 100,000–220,000 km · Medium risk
Signs: Whine or howl under acceleration that rises with engine or road speed, fluid level and pressures otherwise normal
Fix: Have a CVT specialist confirm which bearing is noisy; replace the bearings during an overhaul or fit a reconditioned gearbox before debris damages the pulleys
€1,500–3,500
Scheduled service
Intervals and typical prices for the 1.2 TCe / DIG-T (H5Ft) engine. Other engines differ in oil, timing drive and some filters; the app gives the exact plan.
Roadworthiness tests by mileage
Share of tests in the United Kingdom (DVSA MOT, 2024) that this model failed because of each system. Bold red means more often and green less often than an average car of the same age and mileage. Sample: 21,051 tests.
Roadworthiness tests in the Netherlands by age
Share of this model's Dutch fleet that had a defect in each system at a roadworthiness test (APK) in 2025. Bold red means more often and green less often than an average car of the same age and fuel. Sample: 3,682 cars.
Most common engine versions in the EU
New cars of this generation registered in the EU, Iceland and Norway 2010–2025: 107,618, of which 92 in Croatia. The share shows how common each version is.
Source: European Environment Agency (EEA), monitoring of CO₂ emissions from new passenger cars, CC BY 4.0. CO₂ and fuel use are official type-approval values (WLTP from 2021), not real-world consumption.
Official recalls
Recalls the manufacturer published in the United Kingdom for this model (3). The same recalls usually apply across Europe. Ask an authorised dealer to check by VIN whether your car is affected and whether the work has been done.
- Doors / locks / lids Possible reduced retention force of the rear door child lock switch14/08/2020 · R/2020/220
- Visibility Rear oxygen sensor may fail25/07/2016 · R/2016/157
- Lights Headlight auto levelling system may malfunction when vehicle is fully laden24/03/2016 · R/2016/050
Common questions
Does the Nissan Pulsar have a timing chain or a timing belt?
1.2 TCe / DIG-T (H5Ft): chain; 1.5 dCi (K9K): belt · 120,000 km / every 72 mo.
What are the known problems with the Nissan Pulsar?
The faults with the highest risk: belt slip and pulley wear, debris in the valve body (limp mode) (80,000–200,000 km, €800–4,500); CVT pulley bearing whine (100,000–220,000 km, €1,500–3,500); DPF clogging, failed regenerations (80,000–200,000 km, €150–1,500); injector wear (high return flow, rough running) (150,000–250,000 km, €400–1,400). The full list by engine is on this page.
What does the Nissan Pulsar most often fail its roadworthiness test on?
In UK roadworthiness tests in 2024, at 50–100 thousand km this model most often failed on: suspension (7.9 %), brakes (6.0 %), tyres and wheels (6.0 %). It fails more often than an average car of the same age and mileage on: brakes, suspension, steering. It fails less often than average on: lights, wipers and visibility, body and corrosion.
What should you check when buying a used Nissan Pulsar?
Before you buy, ask an authorised dealer to check by VIN that the recalls have been done (3 have been published for this model). If the engine has a timing belt, ask for the invoice for its replacement: with no proof, assume it has not been done. On the test drive, watch for these signs: judder pulling away, engine revs flare without the car speeding up, delay when selecting D or R, power cut / limp mode when hot; whine or howl under acceleration that rises with engine or road speed, fluid level and pressures otherwise normal. The full checklist is in the guide to buying a used car.
Sources and notes
Faults, intervals and prices are indicative and collected from public sources and owner experience; always rely on the service book and a qualified workshop. Test statistics: DVSA – Anonymised MOT tests and results, Open Government Licence v3.0. Dutch tests: RDW Open Data (CC0). Engine versions: EEA, monitoring of CO₂ emissions from new passenger cars (CC BY 4.0, DG CLIMA). Owner complaints: NHTSA ODI (public domain). Recalls: DVSA Vehicle Safety Branch Recalls Database, OGL v3.0. Brand and model names are trademarks of their owners and are used only to describe the vehicles. How we check the data →
Updated 21/11/2026