This app is in testing and development. The information is indicative and may be inaccurate, so check it with a workshop.
VIN Service Planner
Faults and service for this model with this engine

Peugeot 308 1 1.4 / 1.6 VTi (EP3 / EP6, also MINI N12 / N16)

Petrol · 2007–2013

6
known faults
3
Faults typical of this model
12.8 %
Share

Enter your VIN and mileage and get a plan built for your exact engine and gearbox.

All about the Peugeot 308 1All about the 1.4 / 1.6 VTi (EP3 / EP6, also MINI N12 / N16) engine

The 1.4 / 1.6 VTi (EP3 / EP6, also MINI N12 / N16) engine was fitted to the Peugeot 308 1 (2007–2013). In the EU that is 12.8 % of all new cars of this generation.

Versions: 1.6, 1.6 120 hp, 1.4.

The most expensive known risk is high oil consumption (rings, valve stem seals): it usually appears at 60,000–200,000 km and costs €150–3,000 to fix.

Engine faults ✓ Checked against sources (10/2026)

✓ The faults of this engine were checked against sources (10/2026). Each item has at least two independent sources or an official recall or parts-maker technical note.

Timing chain stretch / tensioner wear

usually 60,000–200,000 km · High risk

Signs: Rattle after a cold start, camshaft timing codes, rough running; a jumped chain bends the valves

Fix: Replace the chain, tensioner, guides and sprockets (with the VVT gears if worn); keep the oil level and change intervals short

€600–1,300

High oil consumption (rings, valve stem seals)

usually 60,000–200,000 km · Medium risk

Signs: Oil needs topping up between services, blue smoke on start or under load, oily spark plugs and carbon in the intake ports

Fix: Rule out leaks and the crankcase breather first; then replace valve stem seals (and guides), or rings / bore work if compression is low

€150–3,000

Valvetronic (variable valve lift) or VVT fault

usually 80,000–200,000 km · Medium risk

Signs: Engine light, rough or hunting idle, loss of power and higher fuel use, valve lift or camshaft timing codes

Fix: Diagnose the Valvetronic motor, eccentric shaft sensor and VVT solenoids; check oil level and pressure first; replace the faulty part

€200–900

Coolant leaks: water pump, thermostat housing, expansion tank

usually 60,000–180,000 km · Medium risk

Signs: Coolant level drops, traces at the pump or housing, temperature warning; overheating can damage the head gasket or head

Fix: Pressure-test the system and replace the leaking water pump, thermostat housing or expansion tank; do not drive while it overheats

€150–500

Persistent misfire: valve seat or cylinder head damage

usually 80,000–220,000 km · High risk

Signs: Misfire on one cylinder that comes back after new plugs and coils, low compression on that cylinder, flashing engine light

Fix: Do a compression or leak-down test before buying more coils; the head must come off for valve seat / valve repair; check the cooling system too

€700–1,500

Oil leaks: valve cover, sump, chain tensioner

usually 60,000–200,000 km · Wear part

Signs: Oil traces on the engine and under the car, burning oil smell, oil level drops without smoke

Fix: Replace the leaking gasket or seal; on 2010-2011 engines check the chain tensioner seal and tightness

€80–350

Faults typical of this model

Electro-hydraulic power steering pump

usually 100,000–220,000 km · Medium risk

Signs: Heavy steering, whine, warning

Fix: Replace the pump / relay

€300–800

Front suspension (top mounts, drop links)

usually 60,000–160,000 km · Wear part

Signs: Knocks over bumps

Fix: Replace parts

€100–300

Brake light switch / BSI electrics

usually 80,000–200,000 km · Wear part

Signs: Warning lights, cruise control off

Fix: Replace switch; BSI update

€30–300

Gearboxes

Manual

Clutch wear

usually 120,000–200,000 km · Medium risk

Signs: Slipping, high bite point

Fix: Replace clutch kit

€500–900

Dual-mass flywheel

usually 150,000–220,000 km · Medium risk

Signs: Rattle at idle, vibration pulling away

Fix: Replace with clutch

€700–1,400

AL4 / AT8 (4-speed automatic)

Pressure-regulation fault: harsh shifts, limp mode stuck in 3rd

usually 80,000–200,000 km · High risk

Signs: Bangs or harsh engagement once warm, 'gearbox faulty' warning and the gearbox stays in 3rd (codes such as P1167 / pressure regulation)

Fix: Check the oil level with the proper procedure first, then replace the pressure-regulating solenoid; if the fault returns, fit a reconditioned valve body and change the oil

€250–1,200

ETG / EGS / BMP / SensoDrive (automated)

Clutch actuator / hydraulic unit

usually 80,000–160,000 km · High risk

Signs: Won't select a gear, 'gearbox fault', jerky shifts

Fix: Repair or replace the actuator; clutch re-learn

€500–1,500

Clutch wear (automated)

usually 80,000–150,000 km · Medium risk

Signs: Slipping, harsh engagement

Fix: Replace clutch + re-learn

€500–1,000

EAT6 / EAT8 (Aisin)

Jerky low-speed shifts and hesitation (software / adaptation)

usually 20,000–240,000 km · Wear part

Signs: Jerks or clunks when slowing down or in town traffic, hesitation when pulling away, flare or slip when cold

Fix: Ask for the latest gearbox software and an adaptation reset; check the oil level and condition

€0–300

Valve body / internal clutch wear from aged fluid (high mileage)

usually 120,000–250,000 km · Medium risk

Signs: Harsh or slipping shifts that get worse over time, dark burnt-smelling fluid, gearbox warning or limp mode

Fix: Change the fluid (several partial changes or a machine change with the correct Aisin / PSA fluid); if shifts stay bad, repair the valve body / solenoids or overhaul the gearbox

€300–3,000

Service plan for this engine

Typical routine maintenance cost for 100,000 km: €2,500–5,550. Sum of the services and wear parts in the plan above (about 15,000 km a year, independent workshop), without faults.

Intervals and typical prices for the Peugeot 308 1 with the 1.4 / 1.6 VTi (EP3 / EP6, also MINI N12 / N16) engine. The app gives the exact plan for your mileage.

ItemIntervalTypical price
Engine oil + oil filterEngineevery 10,000 km or every 12 months€70–150
Cabin (pollen) filterClimateevery 15,000 km or every 12 months€15–40
Brake fluidBrakesevery 24 months€50–95
A/C service (regas + desiccant)Climateevery 24 months€70–150
Air filterEngineevery 30,000 km or every 24 months€15–45
Spark plugsIgnitionevery 60,000 km or every 48 months€50–160
Auxiliary (serpentine) beltEngineevery 120,000 km€70–180
Coolant replacementCoolingevery 150,000 km or every 96 months€70–150
Timing chain inspection (listen on cold start)Engineevery 150,000 km€0–120
Manual gearbox oilTransmissionevery 150,000 km€60–130
Front brake padsBrakesusually at 30,000–60,000 km€60–150
Front brake discs + padsBrakesusually at 60,000–120,000 km€150–320
Rear brake padsBrakesusually at 50,000–90,000 km€50–130
Tyres (set of 4)Wheelsusually at 40,000–60,000 km€320–700
Wiper bladesBodychecked at service€20–50
12V batteryElectricalchecked at service€100–220

Versions of this engine in the Peugeot 308 1

VersionShareYearsCO₂Fuel use
1.6 Petrol1,598 cm³9.4 %2010–2012——
1.6 Petrol1,598 cm³ · 88 kW (120 hp)5.2 %2011–2012——
1.4 Petrol1,397 cm³1.7 %2010–2012——

Source: European Environment Agency (EEA), monitoring of CO₂ emissions from new passenger cars, CC BY 4.0. CO₂ and fuel use are official type-approval values (WLTP from 2021), not real-world consumption.

Official recalls

Recalls the manufacturer published in the United Kingdom for this model (22). The same recalls usually apply across Europe. Ask an authorised dealer to check by VIN whether your car is affected and whether the work has been done.

  • Brakes / ABS / ESP The brake vacuum pump may be affected by material detaching from the timing belt20/01/2021 · R/2020/326
  • Engine / loss of power Due to the calibration of the engine management software the NOX emissions may not comply with regulatory limits26/09/2019 · R/2019/330
  • Fire risk Engine may overheat14/02/2018 · R/2018/048
  • Electronics / software Starter supply wire may chafe06/07/2017 · R/2017/215
  • Fuel system Fuel may leak09/12/2015 · R/2015/241
  • Suspension / axles Possibility of loss of directional control26/05/2015 · R/2015/100
  • Gearbox The incorrect gear may be selected17/12/2014 · R/2014/175
  • Visibility Rear screen could detach09/10/2013 · R/2013/118

Common questions

What are the biggest risks of the Peugeot 308 1 with the 1.4 / 1.6 VTi (EP3 / EP6, also MINI N12 / N16) engine?

The faults with the highest risk: persistent misfire: valve seat or cylinder head damage (80,000–220,000 km, €700–1,500); timing chain stretch / tensioner wear (60,000–200,000 km, €600–1,300); high oil consumption (rings, valve stem seals) (60,000–200,000 km, €150–3,000); valvetronic (variable valve lift) or VVT fault (80,000–200,000 km, €200–900).

Does the Peugeot 308 1 1.4 / 1.6 VTi (EP3 / EP6, also MINI N12 / N16) have a timing belt or a chain?

Chain.

Which oil does the Peugeot 308 1 1.4 / 1.6 VTi (EP3 / EP6, also MINI N12 / N16) need?

5W-30 / 0W-30 · PSA B71 2290 / BMW LL-04 · ~4.25 L · every 10,000 km.

The same model with other engines

1.6 HDi / TDCi / e-HDi (DV6, 8v / 16v)2.0 HDi / TDCi / BlueHDi (DW10)1.6 THP (EP6 turbo, also MINI Cooper S)

Other models with the 1.4 / 1.6 VTi (EP3 / EP6, also MINI N12 / N16) engine

MINI Hatch (R56) 2006–2013Peugeot 207 2006–2014Citroën C4 II 2010–2018MINI Countryman (R60) 2010–2016Citroën C3 Picasso 2009–2017

Sources and notes

Main sources for the faults of this engine:

Faults, intervals and prices are indicative and collected from public sources and owner experience; always rely on the service book and a qualified workshop. Test statistics: DVSA – Anonymised MOT tests and results, Open Government Licence v3.0. Dutch tests: RDW Open Data (CC0). Engine versions: EEA, monitoring of CO₂ emissions from new passenger cars (CC BY 4.0, DG CLIMA). Owner complaints: NHTSA ODI (public domain). Recalls: DVSA Vehicle Safety Branch Recalls Database, OGL v3.0. Brand and model names are trademarks of their owners and are used only to describe the vehicles. How we check the data →

Updated 29/10/2026