The Hyundai i10 III has been built since 2019.
For this generation we cover 2 engines and 9 known faults, each with the mileage range where it usually appears.
The most expensive known risk is timing chain tensioner / chain stretch: rattle on cold start: it usually appears at 40,000–150,000 km and costs €500–1,500 to fix.
In UK roadworthiness tests in 2024, at 0–50 thousand km this model most often failed on: lights, wipers and visibility (9.1 %), tyres and wheels (2.7 %), brakes (1.5 %). It fails more often than an average car of the same age and mileage on: steering, lights, wipers and visibility. It fails less often than average on: tyres and wheels.
Faults by engine
1.0 / 1.2 / 1.4 MPi (Hyundai-Kia Kappa, naturally aspirated) ✓ Checked against sources (10/2026)
Faults and service: Hyundai i10 III with this engine →
Spark plugs fail early: misfire, rough running, no-start
usually 30,000–120,000 km · Medium risk
Signs: Misfire, shaking at idle, flashing engine light, hard starting or no start
Fix: Replace all plugs with the specified type and gap, check the coil on the misfiring cylinder, and do not stretch the plug interval
€50–250
1.0 / 1.4 T-GDi (Hyundai-Kia Kappa turbo) ✓ Checked against sources (10/2026)
Timing chain tensioner / chain stretch: rattle on cold start
usually 40,000–150,000 km · High risk
Signs: Rattle for a few seconds after a cold start, later camshaft timing fault codes
Fix: Check chain stretch and the tensioner revision; replace chain, tensioner and guides with the updated parts before the chain can skip
€500–1,500
Coolant leaks (water pump area) and overheating
usually 40,000–160,000 km · Medium risk
Signs: Coolant level drops, traces of coolant near the water pump, temperature rising in traffic or summer
Fix: Pressure-test the cooling system; replace the water pump or leaking seals, check thermostats and the radiator; do not keep driving if it overheats
€150–700
Carbon build-up on intake valves (direct injection)
usually 60,000–150,000 km · Medium risk
Signs: Rough idle, hesitation, misfire when cold, slight loss of power
Fix: Inspect the valves with a scope and clean them (walnut blasting); sprays give little result
€300–700
Spark plugs fail early: misfire, rough running
usually 30,000–120,000 km · Medium risk
Signs: Misfire, shaking at idle, flashing engine light, hard starting
Fix: Replace all plugs with the specified type and gap, check the coil on the misfiring cylinder, do not stretch the plug interval
€80–300
Injector fouling or early injector wear
usually 60,000–150,000 km · Medium risk
Signs: Loss of power, uneven running, misfire codes, engine light
Fix: Check injector balance and fuel trims; clean or replace the faulty injector with new seals
€200–900
Gearboxes
Manual
Clutch wear
usually 120,000–200,000 km · Medium risk
Signs: Slipping, high bite point
Fix: Replace clutch kit
€500–900
Automated manual (single clutch)
Clutch actuator / hydraulic unit
usually 80,000–160,000 km · High risk
Signs: Won't select a gear, 'gearbox fault', jerky shifts
Fix: Repair or replace the actuator; clutch re-learn
€500–1,500
Clutch wear (automated)
usually 80,000–150,000 km · Medium risk
Signs: Slipping, harsh engagement
Fix: Replace clutch + re-learn
€500–1,000
Scheduled service
Intervals and typical prices for the 1.0 / 1.2 / 1.4 MPi (Hyundai-Kia Kappa, naturally aspirated) engine. Other engines differ in oil, timing drive and some filters; the app gives the exact plan.
Roadworthiness tests by mileage
Share of tests in the United Kingdom (DVSA MOT, 2024) that this model failed because of each system. Bold red means more often and green less often than an average car of the same age and mileage. Sample: 33,443 tests.
Roadworthiness tests in the Netherlands by age
Share of this model's Dutch fleet that had a defect in each system at a roadworthiness test (APK) in 2025. Bold red means more often and green less often than an average car of the same age and fuel. Sample: 10,764 cars.
Most common engine versions in the EU
New cars of this generation registered in the EU, Iceland and Norway 2010–2025: 289,863, of which 1,022 in Croatia. The share shows how common each version is.
Source: European Environment Agency (EEA), monitoring of CO₂ emissions from new passenger cars, CC BY 4.0. CO₂ and fuel use are official type-approval values (WLTP from 2021), not real-world consumption.
Official recalls
Recalls the manufacturer published in the United Kingdom for this model (4). The same recalls usually apply across Europe. Ask an authorised dealer to check by VIN whether your car is affected and whether the work has been done.
- Fuel system The vehicle fuel pump may have an internal malfunction which may fail over time.06/04/2026 · R/2026/093
- Fuel system The fuel tank may have been produced with a manufacturing defect which may result in fuel leakage in a limited number of vehicles29/09/2025 · R/2025/273
- Engine / loss of power The vehicle exhaust gas recirculation valve may have an internal short circuit which in some cases may result in the vehicle engine stalling.20/01/2025 · R/2024/490
- Seat belt Vehicles fitted with a rear right seat belt pretensioner may experience abnormal performance of the pretensioner during deployment27/06/2022 · R/2022/163
Common questions
Does the Hyundai i10 III have a timing chain or a timing belt?
1.0 / 1.2 / 1.4 MPi (Hyundai-Kia Kappa, naturally aspirated): chain; 1.0 / 1.4 T-GDi (Hyundai-Kia Kappa turbo): chain.
What are the known problems with the Hyundai i10 III?
The faults with the highest risk: timing chain tensioner / chain stretch: rattle on cold start (40,000–150,000 km, €500–1,500); clutch actuator / hydraulic unit (80,000–160,000 km, €500–1,500); clutch wear (automated) (80,000–150,000 km, €500–1,000); injector fouling or early injector wear (60,000–150,000 km, €200–900). The full list by engine is on this page.
What does the Hyundai i10 III most often fail its roadworthiness test on?
In UK roadworthiness tests in 2024, at 0–50 thousand km this model most often failed on: lights, wipers and visibility (9.1 %), tyres and wheels (2.7 %), brakes (1.5 %). It fails more often than an average car of the same age and mileage on: steering, lights, wipers and visibility. It fails less often than average on: tyres and wheels.
What should you check when buying a used Hyundai i10 III?
Before you buy, ask an authorised dealer to check by VIN that the recalls have been done (4 have been published for this model). On the test drive, watch for these signs: rattle for a few seconds after a cold start, later camshaft timing fault codes; won't select a gear, 'gearbox fault', jerky shifts. The full checklist is in the guide to buying a used car.
Sources and notes
Faults, intervals and prices are indicative and collected from public sources and owner experience; always rely on the service book and a qualified workshop. Test statistics: DVSA – Anonymised MOT tests and results, Open Government Licence v3.0. Dutch tests: RDW Open Data (CC0). Engine versions: EEA, monitoring of CO₂ emissions from new passenger cars (CC BY 4.0, DG CLIMA). Owner complaints: NHTSA ODI (public domain). Recalls: DVSA Vehicle Safety Branch Recalls Database, OGL v3.0. Brand and model names are trademarks of their owners and are used only to describe the vehicles. How we check the data →
Updated 21/11/2026