Petrol · 2011–2018
Enter your VIN and mileage and get a plan built for your exact engine and gearbox.
All about the Audi Q3 (8U)All about the 1.8 / 2.0 TSI / TFSI (EA888) engine
The 2.0 TSI / TFSI (EA888) engine was fitted to the Audi Q3 (8U) (2011–2018). In the EU that is 10.2 % of all new cars of this generation.
Versions: 2.0 170 hp, 2.0 179 hp.
The most expensive known risk is turbo wastegate actuator wear (boost faults, limp mode): it usually appears at 80,000–200,000 km and costs €300–1,800 to fix.
✓ The faults of this engine were checked against sources (10/2026). Each item has at least two independent sources or an official recall or parts-maker technical note.
Signs: 1 L or more per 1,000 km, blue smoke, oily spark plugs; running low on oil can damage the chain and bearings
Fix: Rule out PCV and turbo first, then a measured consumption test; fit revised pistons and rings and renew the timing chain and tensioner at the same time
Signs: Rattle for a few seconds after a cold start, codes P0016 / P0017; a chain that jumps bends the valves
Fix: Check chain stretch in live data; fit the revised tensioner 06K109467K and, if the chain is stretched, the chain, guides and gears as a set
Signs: Oil pressure warning at various revs, rattle from the lower front of the engine
Fix: Stop the engine; measure oil pressure, check the oil pickup screen, the lower chain with its tensioner and guide, and the balance shafts; replace as a set
Signs: Coolant loss, coolant smell, fluctuating temperature gauge, slow warm-up or overheating warning
Fix: Find the leak with UV dye or a pressure test; replace the pump and thermostat module as one unit
Signs: Rough idle, misfires when cold, power loss, higher fuel use
Fix: Inspect the valves with an endoscope; clean the intake ports (walnut blasting or by hand)
Signs: Engine light with P2015, rough idle, whistling (vacuum leak) if the linkage pops off
Fix: Check the linkage and stops and clean off carbon; replace the intake manifold (latest version) and adapt the flaps
Signs: Whistle or hiss at idle, rough idle, lean codes (P0171), higher oil use, oil leaks at seals
Fix: Check fuel trims in live data; replace the PCV valve / oil separator
Signs: Power loss, boost pressure codes (e.g. P0299), limp mode
Fix: Compare set and actual boost in live data to rule out leaks; repair or replace the actuator, or the turbo if the wastegate itself is worn
Signs: Doors don't lock / unlock, warning on the dash
Fix: Replace the lock unit
Signs: Knock over bumps, vague rear end
Fix: Replace bushes
Signs: Wet carpets, electrical faults
Fix: Clear drains; dry and check modules
Signs: Fan runs constantly or not at all
Fix: Replace fan / module
Signs: Slipping, high bite point
Fix: Replace clutch kit
Signs: Rattle at idle, vibration pulling away
Fix: Replace with clutch
Signs: Jerky or hard shifts, flashing gear display, odd or even gears drop out, then limp mode or the car will not move (codes such as P17BF)
Fix: Have the hydraulic pressure checked by a DSG specialist; repair the housing / accumulator with a revised kit or fit a reconditioned mechatronic unit, then run the adaptations
Signs: Gearbox warning and sudden loss of drive (clutches open, car freewheels), usually just after starting; gearbox fuse found blown
Fix: Check whether the recall / service action was done (control unit and mechatronic oil change); otherwise repair or replace the control unit and use the current oil
Signs: Judder or shudder when pulling away or parking, slipping, burning smell, warning to stop when the clutch is hot
Fix: Read clutch wear and adaptation values with a dealer-level tester; reset adaptations first, replace the double clutch (with release levers / bearings) if worn
Signs: Gearbox warning, odd or even gears (1-3-5 or 2-4-R) drop out, delayed or wrong shifts, limp mode or no drive
Fix: Diagnose with a dealer-level tester; repair the control unit / solenoids or fit a reconditioned mechatronic unit, change the oil and filter and run the adaptations
Signs: Knock or jerk when shifting down into 3rd or 2nd in traffic, a pause of 1-3 seconds before the car pulls away
Fix: Ask the dealer for the latest gearbox software, change the oil and filter and reset the adaptations; if it persists, have the mechatronic checked
Typical routine maintenance cost for 100,000 km: €2,200–4,950. Sum of the services and wear parts in the plan above (about 15,000 km a year, independent workshop), without faults.
Intervals and typical prices for the Audi Q3 (8U) with the 2.0 TSI / TFSI (EA888) engine. The app gives the exact plan for your mileage.
| Item | Interval | Typical price |
|---|---|---|
| Engine oil + oil filterEngine | every 15,000 km or every 12 months | €70–150 |
| Cabin (pollen) filterClimate | every 15,000 km or every 12 months | €15–40 |
| Brake fluidBrakes | every 24 months | €50–95 |
| A/C service (regas + desiccant)Climate | every 24 months | €70–150 |
| Air filterEngine | every 30,000 km or every 24 months | €15–45 |
| Spark plugsIgnition | every 60,000 km or every 48 months | €50–160 |
| Auxiliary (serpentine) beltEngine | every 120,000 km | €70–180 |
| Coolant replacementCooling | every 150,000 km or every 96 months | €70–150 |
| Timing chain inspection (listen on cold start)Engine | every 150,000 km | €0–120 |
| Manual gearbox oilTransmission | every 150,000 km | €60–130 |
| Front brake padsBrakes | usually at 30,000–60,000 km | €60–150 |
| Front brake discs + padsBrakes | usually at 60,000–120,000 km | €150–320 |
| Rear brake padsBrakes | usually at 50,000–90,000 km | €50–130 |
| Tyres (set of 4)Wheels | usually at 40,000–60,000 km | €320–700 |
| Wiper bladesBody | checked at service | €20–50 |
| 12V batteryElectrical | checked at service | €100–220 |
| Version | Share | Years | CO₂ | Fuel use |
|---|---|---|---|---|
| 2.0 Petrol1,984 cm³ · 125 kW (170 hp) | 4.8 % | 2011–2015 | — | — |
| 2.0 Petrol1,984 cm³ · 132 kW (179 hp) | 2.3 % | 2015–2017 | 154 g/km | — |
Source: European Environment Agency (EEA), monitoring of CO₂ emissions from new passenger cars, CC BY 4.0. CO₂ and fuel use are official type-approval values (WLTP from 2021), not real-world consumption.
Recalls the manufacturer published in the United Kingdom for this model (3). The same recalls usually apply across Europe. Ask an authorised dealer to check by VIN whether your car is affected and whether the work has been done.
The faults with the highest risk: turbo wastegate actuator wear (boost faults, limp mode) (80,000–200,000 km, €300–1,800); coolant pump / thermostat housing leak (plastic) (60,000–160,000 km, €350–900); radiator fan / control module (100,000–220,000 km, €200–450); water ingress (plenum / sunroof drains) (60,000–250,000 km, €0–400).
Chain.
5W-30 / 5W-40 · VW 504.00 / 502.00 · ~4.6–5.7 L · every 15,000 km.
2.0 TDI (EA288)1.2 / 1.6 / 2.0 TDI CR (EA189)1.2 / 1.4 TSI / TFSI (EA111)1.0 / 1.2 / 1.4 / 1.5 TSI (EA211)2.5 TFSI 5-cyl (Audi RS 3, TT RS, RS Q3)
Audi A4 (B8) 2007–2015Audi A4 (B9) 2015–2024Škoda Superb III 2015–2023SEAT León III 2012–2020Volkswagen Golf VIII 2019–Audi A5 (8T) 2007–2016Škoda Kodiaq I 2016–2024Audi TT (8J / FV) 2006–2023Audi Q5 (FY) 2017–Audi A6 (C8) 2018–Audi A5 (F5) 2016–2024Audi Q3 (F3) 2018–
Main sources for the faults of this engine:
Faults, intervals and prices are indicative and collected from public sources and owner experience; always rely on the service book and a qualified workshop. Test statistics: DVSA – Anonymised MOT tests and results, Open Government Licence v3.0. Dutch tests: RDW Open Data (CC0). Engine versions: EEA, monitoring of CO₂ emissions from new passenger cars (CC BY 4.0, DG CLIMA). Owner complaints: NHTSA ODI (public domain). Recalls: DVSA Vehicle Safety Branch Recalls Database, OGL v3.0. Brand and model names are trademarks of their owners and are used only to describe the vehicles. How we check the data →
Updated 29/10/2026