EGR valve and cooler coking
usually 80,000–160,000 km · Medium risk
Signs: Power loss, limp mode, EGR fault codes (P0401, P0403, P2413)
Fix: Check actual EGR flow in live data, clean or replace the valve; the cooler if it is blocked
€150–900
EGR cooler internal leak
usually 100,000–180,000 km · High risk
Signs: Coolant loss with no visible leak, white smoke after a cold start
Fix: Pressure-test the cooling system and replace the EGR cooler before the cylinder head is damaged
€450–1,300
Intercooler in the intake manifold cracks (coolant leak)
usually 100,000–200,000 km · High risk
Signs: Coolant loss with no visible leak, oily emulsion on the block at cylinder 4 near the bulkhead
Fix: Pressurise the cooling system and inspect the cooler with an endoscope through the charge-air temperature sensor opening; replace the intake manifold with cooler
€600–1,400
Switchable coolant pump: shroud sticks or leaks
usually 80,000–150,000 km · High risk
Signs: Overheating (shroud stuck closed) or slow warm-up and weak heating (stuck open), coolant loss, pink crust near the pump
Fix: Replace the pump, ideally together with the timing belt
€300–1,200
Coolant expansion tank: silicate bag breaks up
usually 60,000–200,000 km · Wear part
Signs: Granules in the coolant, poor cabin heating (clogged heater core)
Fix: Replace the expansion tank and flush the cooling system and heater core
€100–400
DPF clogging
usually 60,000–180,000 km · Medium risk
Signs: DPF light, regeneration every few days, rising oil level (fuel in the oil)
Fix: Longer motorway drives; check soot and ash load and the pressure sensor; forced regeneration, cleaning or replacement
€150–1,800
Oil pump drive belt (in the sump)
usually 150,000–250,000 km · Medium risk
Signs: Oil pressure warning, noise from the lower part of the engine
Fix: Stop the engine at once if the oil pressure light comes on; at high mileage replace the oil pump belt preventively
€300–600
Timing belt tensioner: revised part (engines built before 10/2016)
usually 60,000–210,000 km · Medium risk
model years 2012–2016 only
Signs: Squeal from the timing belt area; a slack belt after a belt change
Fix: Fit the revised tensioner; at a belt change loosen the camshaft and pump sprockets so the tension is even (INA instruction)
€100–300
Injector wear (return flow)
usually 150,000–250,000 km · Medium risk
Signs: Harder starting, louder clatter when cold, rough idle, high return flow on the test
Fix: Return-flow (leak-off) test; recondition or replace the injectors
€400–1,500
High-pressure fuel pump (Bosch CP4)
usually 150,000–300,000 km · Medium risk
Signs: Hard starting, power loss, rail pressure codes; metal particles can reach the injectors
Fix: Replace the pump; if there is metal debris, also injectors, rail and lines, and flush the tank
€1,200–4,000
Turbocharger: sooted vanes, actuator or bearing play
usually 150,000–250,000 km · Medium risk
Signs: Limp mode, boost pressure codes, whistling, oil in the intake
Fix: Clean the variable vanes or repair the actuator; replace or recondition the turbo
€900–2,000
Oil leak from the camshaft housing
usually 120,000–220,000 km · Wear part
Signs: Oil on top of the cylinder head, oil reaching the timing belt
Fix: Reseal the camshaft housing, usually together with the timing belt change
€300–800
Coolant pump / thermostat module leak (plastic housing)
usually 60,000–150,000 km · Medium risk
Signs: Coolant level slowly drops, pink crust or damp at the gearbox end of the cylinder head, sweet smell after driving
Fix: Pressure-test the system, replace the pump and thermostat module together with its small drive belt, then bleed the system using diagnostics
€300–700
Turbo wastegate linkage rattles or seizes
usually 40,000–150,000 km · Wear part
Signs: Metallic rattle from the turbo at idle, low revs or when coasting; if the rod seizes, underboost (P0299) and reduced power
Fix: Fit the VW linkage repair kit (rod, washer, clip) and lubricate it with high-temperature paste; replace the actuator or turbo only if they have failed
€100–1,200
Recall: camshaft adjuster bolts loosen (1.2 TSI built 2014–2015)
usually 0–200,000 km · High risk
model years 2014–2015 onlyengine codes: CJZA, CJZB, CJZC, CJZD, CYVA, CYVB
Signs: Usually no warning; then oil leak at the timing end, rough running or camshaft timing faults; a broken adjuster pulley can wreck the timing drive
Fix: Check by VIN whether recall 15H4 (Škoda) or the matching VW / SEAT action was done; the adjuster is replaced free of charge
free / recall
Oil consumption on early 1.4 TSI 122 / 125 PS (2012–2015)
usually 60,000–200,000 km · Wear part
model years 2012–2015 onlyengine codes: CMBA, CPVB, CXSA, CPVA, CZCA
Signs: Oil top-ups needed between services, in bad cases more than 0.5 l per 1,000 km
Fix: Rule out leaks and crankcase ventilation first, then do a measured oil consumption test; replace the piston rings if it is confirmed
€100–2,500
Ignition coil failure
usually 60,000–180,000 km · Wear part
Signs: Misfire, shaking at idle, flashing engine light, codes P0300–P0304
Fix: Swap coils between cylinders to confirm the fault, replace the faulty coil and check the spark plugs
€50–300
Carbon deposits on the intake valves (direct injection)
usually 100,000–220,000 km · Wear part
Signs: Rough cold idle, misfires, weaker response and higher fuel use at high mileage, mostly in cars used for short trips
Fix: Confirm with an endoscope through the intake ports and clean the valves mechanically (walnut blasting); fuel additives do not reach the valves
€250–600
High oil consumption: piston rings (Gen 2, 2008–2013)
usually 40,000–150,000 km · High risk
model years 2008–2013 onlyengine codes: CDAA, CDAB, CDHA, CDHB, CCZA, CCZB
Signs: 1 L or more per 1,000 km, blue smoke, oily spark plugs; running low on oil can damage the chain and bearings
Fix: Rule out PCV and turbo first, then a measured consumption test; fit revised pistons and rings and renew the timing chain and tensioner at the same time
€2,000–5,000
Timing chain tensioner (old type) lets the chain jump (Gen 1/2)
usually 60,000–200,000 km · High risk
model years 2007–2015 onlyengine codes: BYT, BZB, CABA, CABB, CABD, CAWA
Signs: Rattle for a few seconds after a cold start, codes P0016 / P0017; a chain that jumps bends the valves
Fix: Check chain stretch in live data; fit the revised tensioner 06K109467K and, if the chain is stretched, the chain, guides and gears as a set
€600–1,500
Oil pressure loss: balance shaft / oil pump drive (Gen 1/2)
usually 100,000–250,000 km · High risk
model years 2007–2015 onlyengine codes: BYT, BZB, CABA, CABB, CABD, CAWA
Signs: Oil pressure warning at various revs, rattle from the lower front of the engine
Fix: Stop the engine; measure oil pressure, check the oil pickup screen, the lower chain with its tensioner and guide, and the balance shafts; replace as a set
€800–2,500
Coolant pump / thermostat housing leak (plastic)
usually 60,000–160,000 km · Medium risk
Signs: Coolant loss, coolant smell, fluctuating temperature gauge, slow warm-up or overheating warning
Fix: Find the leak with UV dye or a pressure test; replace the pump and thermostat module as one unit
€350–900
Carbon build-up on intake valves (Gen 1/2, direct injection only)
usually 80,000–180,000 km · Medium risk
model years 2007–2015 onlyengine codes: BYT, BZB, CABA, CABB, CABD, CAWA
Signs: Rough idle, misfires when cold, power loss, higher fuel use
Fix: Inspect the valves with an endoscope; clean the intake ports (walnut blasting or by hand)
€300–700
Intake manifold flap actuator or linkage (P2015, Gen 1/2)
usually 80,000–180,000 km · Medium risk
model years 2007–2015 onlyengine codes: BYT, BZB, CABA, CABB, CABD, CAWA
Signs: Engine light with P2015, rough idle, whistling (vacuum leak) if the linkage pops off
Fix: Check the linkage and stops and clean off carbon; replace the intake manifold (latest version) and adapt the flaps
€200–900
Crankcase ventilation (PCV) valve: torn membrane
usually 60,000–150,000 km · Wear part
Signs: Whistle or hiss at idle, rough idle, lean codes (P0171), higher oil use, oil leaks at seals
Fix: Check fuel trims in live data; replace the PCV valve / oil separator
€100–350
Turbo wastegate actuator wear (boost faults, limp mode)
usually 80,000–200,000 km · Medium risk
Signs: Power loss, boost pressure codes (e.g. P0299), limp mode
Fix: Compare set and actual boost in live data to rule out leaks; repair or replace the actuator, or the turbo if the wastegate itself is worn
€300–1,800
Recall: high-voltage battery junction box fuse, fire / shock risk (2019-2022)
usually 0–150,000 km · High risk
model years 2019–2022 only
Signs: Usually no warning; in an overvoltage event the fuse may not work, with a risk of fire or electric shock
Fix: Have a dealer check by VIN that the recall is done (VW code 93N4, Skoda 93O5); an extra insulating mat is fitted over the junction box free of charge
free / recall
Charging faults or hybrid-system warnings (often fixed by software)
usually 20,000–160,000 km · Medium risk
Signs: Car will not charge or stops charging, hybrid-system warning, no electric mode, rarely a full electrical shutdown
Fix: Read the fault memory; check for software updates first, then the charging cable, socket and on-board charger, and the 12 V battery
€0–1,500
Coolant pump / thermostat module leak (plastic housing)
usually 60,000–150,000 km · Medium risk
Signs: Coolant level slowly drops, pink crust or damp at the gearbox end of the cylinder head, sweet smell after driving
Fix: Pressure-test the system, replace the pump and thermostat module together with its small drive belt, then bleed the system using diagnostics
€300–750
Turbo wastegate linkage rattles or seizes
usually 40,000–150,000 km · Wear part
Signs: Metallic rattle from the turbo at idle or when the engine starts and stops; if the rod seizes, underboost (P0299) and reduced power
Fix: Fit the VW linkage repair kit (rod, washer, clip) and lubricate it with high-temperature paste; replace the actuator or turbo only if they have failed
€100–1,200