This app is in testing and development. The information is indicative and may be inaccurate, so check it with a workshop.
VIN Service Planner
Faults and service for this model with this engine

Mercedes-Benz CLS (C218) 3.0 CDI V6 (Mercedes OM642)

Diesel · 2011–2018

9
known faults
1
Faults typical of this model
51.5 %
Share

Enter your VIN and mileage and get a plan built for your exact engine and gearbox.

All about the Mercedes-Benz CLS (C218)All about the 3.0 CDI V6 (Mercedes OM642) engine

The 3.0 CDI V6 (Mercedes OM642) engine was fitted to the Mercedes-Benz CLS (C218) (2011–2018). In the EU that is 51.5 % of all new cars of this generation.

Versions: 3.0 265 hp, 3.0, 3.0 258 hp, 3.0 252 hp.

The most expensive known risk is timing chain stretch at high mileage (rear-mounted duplex chain): it usually appears at 200,000–350,000 km and costs €1,500–3,500 to fix.

Engine faults ✓ Checked against sources (11/2026)

✓ The faults of this engine were checked against sources (11/2026). Each item has at least two independent sources or an official recall or parts-maker technical note.

Oil leak from the oil cooler seals in the V of the engine

usually 120,000–250,000 km · Medium risk

Signs: Oil at the back of the engine or the gearbox bellhousing and drops under the car while the top of the engine looks dry

Fix: Check the V of the engine and its drain hole before blaming the rear crank seal; replace the cooler seals with the revised Viton seals and renew the turbo, EGR and intake seals while it is apart

€900–2,000

Intake shut-off motor (EKAS) or swirl flaps fail

usually 100,000–220,000 km · Medium risk

Signs: Limp mode with poor pull at low revs, engine light (P2004 / P2005), sometimes a blown fuse that makes other parts report faults

Fix: Test the flap motor and check for oil dripping on it from the clean-air duct seal; replace that seal with the motor, and replace the intake manifold if the flaps or linkage are coked or broken

€300–1,800

Turbo boost actuator fails (power loss when hot)

usually 120,000–250,000 km · Medium risk

Signs: Power loss uphill or under load once warm, P0299 / low boost, jerking at part load; a restart often clears it for a while

Fix: Test the electronic actuator when hot and check the turbo vanes move freely; replace or repair the actuator, and the turbo only if the vane mechanism is seized

€400–2,500

Cracked sheet-metal exhaust manifold (can damage the turbo)

usually 150,000–300,000 km · High risk

Signs: Metallic ticking under load, soot at the manifold flange, exhaust smell, power loss

Fix: Inspect the manifolds for cracks (and with an endoscope) before any turbo replacement; replace the cracked manifold, otherwise loose pieces will destroy the new turbo

€600–2,500

EGR valve and cooler coking

usually 100,000–220,000 km · Medium risk

Signs: Hesitation at part load, sluggish response, P0401 / P0402, smoke; a leaking cooler loses coolant

Fix: Run the EGR actuator test and compare with the air mass reading; clean or replace the valve, and the cooler if blocked or leaking

€300–1,500

DPF clogging (short trips or limp mode)

usually 100,000–250,000 km · Medium risk

Signs: DPF warning, frequent or failed regenerations, limp mode

Fix: First fix any EGR, flap or boost fault that stops regeneration and check the pressure sensor; then forced regeneration, cleaning or replacement; use low-ash MB 229.51 / 229.52 oil

€150–2,000

Timing chain stretch at high mileage (rear-mounted duplex chain)

usually 200,000–350,000 km · High risk

Signs: Hard metallic rattle for several seconds after a cold start, later longer; cam-crank timing codes

Fix: Read the cam-crank offset and measure stretch; replace chain, tensioner and guides if out of limits; short oil change intervals prevent it

€1,500–3,500

Injector wear or leaking injector copper seals

usually 150,000–300,000 km · Medium risk

Signs: Long starts, hard knocking, rough running, soot or diesel smell around an injector, fuel in the oil

Fix: Check the per-cylinder quantity corrections and do a return-flow test; replace the faulty injector or its seal rather than the whole set

€200–2,000

Emissions recall: engine software update

at any mileage · Wear part
model years 2009–2018 only

Signs: No symptoms; an open recall can cause registration problems

Fix: Have a dealer check by VIN that the free software update was done

free / recall

Faults typical of this model

Air suspension (Airmatic)

usually 100,000–200,000 km · Medium risk

Signs: Car sits low, compressor runs long

Fix: Replace strut / compressor

€700–2,200

Gearboxes

5G / 7G / 9G-Tronic

7G-Tronic conductor plate / speed sensor failure (limp mode)

usually 100,000–250,000 km · High risk
model years 2003–2018 only

Signs: Holds a gear too long then shifts hard, sticks in gear or limp mode, converter lock-up stops working; codes 0717 / 0718 / 0722 / 2201

Fix: Confirm with Mercedes-level diagnostics; replace or rebuild the conductor plate (with the valve body on early VGS1 units), change the fluid with the correct MB spec and code / adapt the unit

€700–2,500

9G-Tronic mechatronic / pressure sensor fault (no reverse, limp mode)

usually 60,000–200,000 km · High risk
model years 2014–2027 only

Signs: Harsh shifts when warm, drops from D to N at stops, starts in 3rd, reverse will not engage, 'F' on the dash; codes P073E00, P07B700

Fix: Read the codes and fluid condition; repair / rebuild the mechatronic (pressure sensors) or replace it, then change the fluid and run the adaptations

€800–3,000

Service plan for this engine

Typical routine maintenance cost for 100,000 km: €2,600–6,200. Sum of the services and wear parts in the plan above (about 15,000 km a year, independent workshop), without faults.

Intervals and typical prices for the Mercedes-Benz CLS (C218) with the 3.0 CDI V6 (Mercedes OM642) engine. The app gives the exact plan for your mileage.

ItemIntervalTypical price
DPF health check (soot / ash load)Emissionsevery 20,000 km€0–60
Engine oil + oil filterEngineevery 15,000 km or every 12 months€70–150
Cabin (pollen) filterClimateevery 15,000 km or every 12 months€15–40
Brake fluidBrakesevery 24 months€50–95
A/C service (regas + desiccant)Climateevery 24 months€70–150
Air filterEngineevery 30,000 km or every 24 months€15–45
Fuel filterFuelevery 30,000 km or every 24 months€40–110
Automatic transmission fluidTransmissionevery 90,000 km€200–450
Glow plugsEngineevery 100,000 km€120–300
Auxiliary (serpentine) beltEngineevery 120,000 km€70–180
Coolant replacementCoolingevery 150,000 km or every 96 months€70–150
Timing chain inspection (listen on cold start)Engineevery 150,000 km€0–120
Front brake padsBrakesusually at 30,000–60,000 km€60–150
Front brake discs + padsBrakesusually at 60,000–120,000 km€150–320
Rear brake padsBrakesusually at 50,000–90,000 km€50–130
Tyres (set of 4)Wheelsusually at 40,000–60,000 km€320–700
Wiper bladesBodychecked at service€20–50
12V batteryElectricalchecked at service€100–220

Versions of this engine in the Mercedes-Benz CLS (C218)

VersionShareYearsCO₂Fuel use
3.0 Diesel2,987 cm³ · 195 kW (265 hp)23.4 %2011–2017165 g/km—
3.0 Diesel2,987 cm³14.5 %2011–2017146 g/km—
3.0 Diesel2,987 cm³ · 190 kW (258 hp)9.0 %2014–2017161 g/km—
3.0 Diesel2,987 cm³ · 185 kW (252 hp)4.5 %2013–2017164 g/km—

Source: European Environment Agency (EEA), monitoring of CO₂ emissions from new passenger cars, CC BY 4.0. CO₂ and fuel use are official type-approval values (WLTP from 2021), not real-world consumption.

Common questions

What are the biggest risks of the Mercedes-Benz CLS (C218) with the 3.0 CDI V6 (Mercedes OM642) engine?

The faults with the highest risk: timing chain stretch at high mileage (rear-mounted duplex chain) (200,000–350,000 km, €1,500–3,500); cracked sheet-metal exhaust manifold (can damage the turbo) (150,000–300,000 km, €600–2,500); turbo boost actuator fails (power loss when hot) (120,000–250,000 km, €400–2,500); air suspension (Airmatic) (100,000–200,000 km, €700–2,200).

Does the Mercedes-Benz CLS (C218) 3.0 CDI V6 (Mercedes OM642) have a timing belt or a chain?

Chain.

Which oil does the Mercedes-Benz CLS (C218) 3.0 CDI V6 (Mercedes OM642) need?

5W-30 · MB 229.51 · ~8.0 L · every 15,000 km.

The same model with other engines

2.1 CDI (Mercedes OM651)3.0 / 3.5 V6 petrol (Mercedes M276)

Other models with the 3.0 CDI V6 (Mercedes OM642) engine

Mercedes-Benz E-Class (W212) 2009–2016Mercedes-Benz ML / GLE (W166) 2011–2019Mercedes-Benz S-Class (W222) 2013–2020

Sources and notes

Main sources for the faults of this engine:

Faults, intervals and prices are indicative and collected from public sources and owner experience; always rely on the service book and a qualified workshop. Test statistics: DVSA – Anonymised MOT tests and results, Open Government Licence v3.0. Dutch tests: RDW Open Data (CC0). Engine versions: EEA, monitoring of CO₂ emissions from new passenger cars (CC BY 4.0, DG CLIMA). Owner complaints: NHTSA ODI (public domain). Recalls: DVSA Vehicle Safety Branch Recalls Database, OGL v3.0. Brand and model names are trademarks of their owners and are used only to describe the vehicles. How we check the data →

Updated 21/11/2026